| 100 |
Failed to Connect to PhyzBatch |
Flip the main power switch off, then on. |
| 101 |
Serial Connection Lost |
Flip the main power switch off, then on. |
| 102 |
Conveyor Motor Disconnected |
Make sure conveyor plug connected to scanner. |
| 103 |
Rapid Change in Conveyor Motor RPM |
Check for and remove any stuck cards and check for and replace stuck bearings. |
| 104 |
Camera Blackout |
Flap the main power switch off, then on. Check for blockage covering internal camera. |
| 105 |
Camera Connection Lost |
Flip the main power switch off, then on. |
| 106 |
Camera Failed to Connect |
Flip the main power switch off, then on. |
| 107 |
Camera Obstructed |
Run Regenerate Dock Photo, adjust as necessary and then run the command gain. |
| 108 |
Double Feed |
Adjust your card sorter foot downwards and continue. |
| 109 |
Entry Sensor Blocked |
Clean Feed Wheels, adjust foot up or down as required |
| 110 |
Exit Sensor Blocked |
Check for Double Feed cards, check that the metal plate pushes the glass up against the foam rollers. |
| 111 |
Position Rollers Slipping |
Check that the metal plate pushes the glass up against the foam rollers. |
| 112 |
Empty Hopper |
Clean the feed wheels. adjust foot height, check tail distance from feeder |
| 113 |
Exit Sensor Failed to Trigger |
Check that the metal plate pushes the glass up against the foam rollers. |
| 114 |
Entry Sensor Failed to Trigger |
Clean the feed wheels. adjust foot height, check tail distance from feeder |
| 201 |
Invalid Sort ID |
Data mismatch. End sort and start a new one. |
| 204 |
Missing MTG card ID |
Run a software update for the latest card data. |
| 205 |
Missing Pokémon card ID |
Run a software update for the latest card data. |
| 206 |
Missing Lorcana card ID |
Run a software update for the latest card data. |
| 207 |
Missing One Piece card ID |
Run a software update for the latest card data. |
| 999 |
Unspecified error. |
Contact Support. |
